SL32~sl36 surface mount low vf schottky rectifiers features low profile package ideal for automated placement ultrafast reverse recovery time low power losses, high efficiency low forward voltage drop high surge capability high temperature soldering 260 /10 seconds at terminals component in accordance to rohs 2002/95/1 and weee 2002/96/ec mechanical date major ratings and characteristics case: jedec do-214ac molded plastic body over glass passivated chip terminals: solder plated, solderable per j-std-002b and jesd22-b102d i f(av) 3.0a v rrm 20 v to 60 v i fsm 100a v f 0.40v, 0.65 v polarity: laser band denotes cathode end maximum ratings & thermal characteristics (t a = 25 c unless otherwise noted) note 1: mounted on p.c.b. with 0.2 x 0.2? (5.0 x 5.0mm) copper pad areas. electrical characteristics (t a = 25 c unless otherwise noted) note 2: pulse test:300 s pulse width,1% duty cycle. t j max. 125 c items symbol SL32 sl33 sl34 sl36 unit maximum repetitive peak reverse voltage v rrm 20 30 40 60 v maximum rms voltage v rms 14 21 28 42 v maximum dc blocking voltage v dc 20 30 40 60 v a maximum average forward rectified current i f(av) 3 a v/s peak forward surge current 8.3 ms single half sine- wave superimposed on rated load i fsm 100 voltage rate of change (rated v r ) dv/dt 10000 /w thermal resistance from junction to lead (1) r jl 35 operating junction and st orage temperature range t j t stg ?65 to +125 items test conditions symbol SL32~34 instantaneous forward voltage i f =3.0a (2) v f 0.40 ma unit v sl36 0.65 v r =v dc t a =25 i r 1.0 reverse current t a =100 20 http://www.trr-jx.com
SL32~sl36 characteristic curves (t a =25 unless otherwise noted) http://www.trr-jx.com surface mount low vf schottky rectifiers
SL32~sl36 package outline notice product is intended for use in general electronics applications. product should be worked less than the ratings; if exceeded, may cause permanent damage.or introduce latent failure mechanisms. the absolute maximum ratings are rated values and must not be exceeded during operation. the following are the general derating methods you design a circuit with a device. i f(av) : we recommend that the worst case current be no greater than 80% . i fsm : this rating specifies the non-repetitive peak current. this is only applied for an abnormal operation, which the general during the lifespan of the device. t j : derate this rating when using a device in order to ensure high reliability. we recommend that the device be used at a t j of below 125c. trr is registered trademark of rising-sun technology. rising-sun te chnology reserves the right to make changes to any product i n this specification to improve reli ability,functional characterist ics,or design without notice. rising-sun technology does not assure any liability arising out of the applic ations or any product descr ibed in this specificat ion. rising-sun technology advises customers to obtain the latest vers ion of the device information before placing orders to verify that the required information is current. http://www.trr-jx.com surface mount low vf schottky rectifiers
|
